I recently purchased the following power switch for my Raspberry PI 5 switch:
https://www.amazon.com/dp/B096TZJNXH?re ... title&th=1
I solder and connected the power button to the J2 jumper, and it works great. I'm running into the issue of getting the LEDs on the power button to come on and off. I used the physical pins 5 and 6 to connect the LEDs and added dtoverlay=gpio-shutdown and enable_uart=1 to the boot config but had no luck. This is my first time working with a Raspberry PI, and I need some advice. I assume a script must be created for startup, but I wanted to come here first. Any advice would be greatly appreciated.
https://www.amazon.com/dp/B096TZJNXH?re ... title&th=1
I solder and connected the power button to the J2 jumper, and it works great. I'm running into the issue of getting the LEDs on the power button to come on and off. I used the physical pins 5 and 6 to connect the LEDs and added dtoverlay=gpio-shutdown and enable_uart=1 to the boot config but had no luck. This is my first time working with a Raspberry PI, and I need some advice. I assume a script must be created for startup, but I wanted to come here first. Any advice would be greatly appreciated.
Statistics: Posted by bootsmcgee — Thu Mar 06, 2025 3:54 am